Filter
Top Products
Charging the Battery Pack
1. Connect the transformer to the charger and
plug the transformer into the wall outlet. A
solid red LED on any empty charger indi-
cates that the charger is idle and ready for
use. If the LED does not light, check the wall
transformer and plug connection to the charg-
er. If the charger appears to be plugged in
correctly, make sure the wall outlet has
power.
2. To remove the Battery Pack from the
Wireless Telephone, slide the Battery Pack
down and off while pressing the Battery Pack
release button on the back of the Wireless
Telephone.
3. Place the Battery Pack on the charger by
aligning the top of the Battery Pack with the
tracks on the charger then gently sliding the
Battery Pack upward onto the charger.
LED Status Indicators
While the Battery Pack is in the charger, the LED
on the charger will indicate the status of the
charging process and/or the Battery Pack.
• Solid Green—the Battery Pack is charging.
The Quick Charger takes 60-90 minutes to
fully charge a Battery Pack. If the NiMH
Battery Pack is hot or cold when placed in
the charger, it may take longer to charge.
• Flashing green—the Battery Pack is fully
charged and ready for use. You may leave a
fully charged Battery Pack in the Quick
Charger. However, if you remove a fully
charged Battery Pack then replace it in the
charger, the charger LED will light solid
green until the charger determines that this
Battery Pack is fully charged. It may take a
few minutes to give the flashing green indi-
cation.
• Solid red or flashing red—the Battery Pack
in the charger is no longer capable of retain-
ing a charge and is not usable. Used Battery
Packs should be disposed of properly.
• Flashing red/green—there is a problem with
either the Battery Pack or charger. It may
mean the Battery Pack being charged is too
hot or too cold. Allow the Battery Pack to
stabilize at room temperature and try again.
If several different Battery Packs cause the
charger to show a flashing red or red/green
LED, the charger may not be working prop-
erly. To verify this, substitute another charger
and repeat the operation that caused the fail-
ure. If the same Battery Pack lights a green
LED when inserted in a different charger, the
first charger is faulty. If the problem contin-
ues, call your Service Representative.