Bahco BE-6990-IP Power Screwdriver User Manual


  Open as PDF
of 2
 
Use
If the screwdriver is turned in the direction of
tightening, you hear a click when the correct torque
has been reached. When undoing screws, there is
no torque limit.
Correct size
The screwdriver has a fixed torque, which is matched to the actual size of the blade.
The size is specified by the identification on the blade and on the handle of the screwdriver.
Changing the blade
As required, the blade can be removed from the handle and replaced by a new blade.
Care must be taken to ensure that the figure on the blade (Nm) agrees with the figure on the handle.
Using different blade profiles
Torque Screwdriver BE-6990-IPcan also be fitted with other blade profiles, e.g. slotted, PHILLIPS, POZIDRIV, hex.
Here too the requirement is that the same tightening torque (Nm) is used.
Nm
Nm
MS7044ENG
1
3
2
Application of the sliding T-handle
In order to apply the required torque with
less effort, the self-locking T-handle can be
inserted into the 1/4" female square at the
end of the handle on models
BE-6990-IP20 and BE-6990-IP25.
When the rod has been pushed through
the insert, the screwdriver is secured to the
T-handle.
1
2
=
=
www.bahco.com
Product code EAN-Code Nm
731415+ mm mm mm
BE-6990-IP6 1846725 0,6 IP6 T6 55 32 x 113 168 100 1
BE-6990-IP7 1846732 0,9 IP7 T7 55 32 x 113 168 100 1
BE-6990-IP8 1846749 1,2 IP8 T8 55 32 x 113 168 100 1
BE-6990-IP9 1846756 1,4 IP9 T9 65 32 x 113 178 100 1
BE-6990-IP10 1846763 2,0 IP10 T10 65 32 x 113 178 100 1
BE-6990-IP15 1846770 3,0 IP15 T15 65 32 x 113 178 100 1
BE-6990-IP20 1848606 5,0 IP20 T20 65 32 x 150 215 337 1
BE-6990-IP25 1848613 7,5 IP25 T25 65 32 x 150 215 337 1
 previous