Filter
Top Products
CABLE TESTER CT100
3
3. INSTALLED CABLE TESTER MODE
This mode enables you to test cables in fixed installations or
situations that dont allow you to connect both ends of the cable to
the CT100.
+ Hold down the RESET button while moving the ON
switch to the CABLE TESTER position. The ON LED will
blink to indicate that the CT100 is in INSTALLED
CABLE TESTER MODE.
To test a cable for short circuits, connect one end of the cable to the
appropriate OUT jack of the CT100. The display works as in CABLE
TESTER MODE (see chapter 2). However, it now indicates
connections between out pins. If no LEDs light, the cable is free of
short circuits.
3.1 Continuity check in INSTALLED CABLE TESTER MODE
For a continuity check, connect a shorting jack (a jack in which pins
are short-circuited to one another) to the other end of the cable. If
there are no breaks in the signal flow, the display will show the
corresponding pins as being shorted to each other. If the display
indicates no short circuit, there is a break in the signal flow.
+ The testing of intermittent connections works
exactly as in CABLE TESTER MODE (see chapter 2.1).
+ INSTALLED CABLE TESTER MODE will not indicate
connections between out and in pins. This is done in
CABLE TESTER MODE (see chapter 2).
4. TEST TONE MODE
+ Move the ON switch to the position TEST TONE.
+ Do not use the TEST TONE MODE for MIDI cables!