Filter
Top Products
benchdog.com
©Copyright Bench Dog Tools, Inc. 2008
Toll Free 800-786-8902 page 19
router table accessories
Mounting to aftermarket fences
(like Fasttrack or Woodhaven).
Mounting to a shop-made or scrap
wood fence.
Mounting T-Loc to your fence makes installing Panel-Loc simple and tool-free.
T-Loc mounted to a simple
shop-made fence. Installation
is easy — just screw it on.
Panel-Loc was developed in
conjunction with acclaimed
woodworker Lonnie Bird,
pictured above in his woodshop. The unique design of Panel-Loc
places downward pressure on your workpiece at just the right
place — 2" away from the fence. This prevents the tipping that
occurs with ordinary featherboards. Panel-Loc also provides
excellent protection from accidental contact with the router bit, and
its long surface area protects you from flying chips and dust.
Panel-Loc includes a 20" length of our T-Loc accessory track for
mounting to most available fences. Fits ALL Bench Dog Tools
router tables.
With ProRiser, you can extend
the height of your fence to
whatever dimension you like!
Just slide the ProRiser brackets
into the rear T-slot of your
Profence and add a piece of
3/4" thick stock. The stock can
be very wide for maximum
support, or it can be a specific
width to allow surface moldings
to slide through un-obstructed.
Includes all necessary hardware;
you just add the fence face.
T-Loc is a horizontal 1/4"
accessory T-track. The T-slot
captures 1/4" hex-head bolts used on
many aftermarket accessories. Use T-Loc to add a
T-slot to your shop-made fences and jigs. T-Loc has many other
uses too, such as a guide, holding stops, or other fixtures. T-Loc is
the best way to attach our Feather-Loc featherboards and other
Bench Dog Tools accessories to your shop-made fence. T-Loc can
also be mounted to many other brands of router table fences. T-Loc
may also be an effective way to add a horizontal T-track to your
table saw’s rip fence. Comes in 36" lengths. May be cut to size.
Mounting will require drilling holes and obtaining proper hardware.
➤ Maximum support for routing boards on edge and for raising panels vertically.
➤ Holds material perfectly square to the table — ideal for precise joinery.
➤ Works with ANY Bench Dog Tools router table.
➤ Protects your hands from large bits!
➤ Fits ALL Bench Dog Tools router tables and fences,as well as most other router table fences.
➤ Holds your panel down firmly for better cuts and completely eliminates unwanted lifting.
➤ Low-friction, UHMW hold-down strip allows your panel to move freely and is non-marring.
➤ For all horizontal raised panel bits.
Give your ProFence a boost in height and performance!
Safer, better results when raising panels!
Stock No. 40-025
U.S. Patent No. 6,481,472
Stock No. 40-013
Developed with
expert input from
Lonnie Bird!
Stock No. 10-013
19 Dog 08 SH 2/4/08 3:04 PM Page 1