Bernard SPEC NC-1.1 Welder User Manual


  Open as PDF
of 2
 
©2008 Bernard Printed in U.S.A.
1. Install rubber insulator from coupler over the end of neck as shown.
2. Install coupler onto end of neck and torque to approximately 12ft-lbs.
3. After coupler is installed onto neck, slide rubber insulator over to cover
exposed brass on coupler.
4. Install second neck into coupler and tighten by hand or with a wrench.
5. Install snap-on nut cover over locknut for hand tightened necks, or the rubber boot
for wrench tightened necks.
1. Lubricate inner diameter of neck grip with silicone spray, dish soap, or water.
2. Install over neck armor and move to desired position. Neck grip can be used
in place of rubber insulator for wrench tightened necks.
Neck Coupler Installation Instructions
Neck Grip Installation Instructions
 previous