Filter
Top Products
724-746-5500 | blackbox.com
Page 20
Chapter 3: Installation
3. Installation
WARNINGS:
Make sure that all devices are powered off before connecting to the unit.
Make sure all devices you will connect are properly grounded.
Place cables away from fluorescent lights, air conditioners, and machines.
NOTE: EDID copy is required for DVI monitors.
System Requirements for PoE
1. Ensure that a PSE device supports PoE function.
2. Ensure that a PSE device can provide sufficient power on the Ethernet cable.
3. STP and FTP cabling are recommended.
Installing the Transmitter and Receiver
1. Connect a video source (PC, Blu-ray, etc.) to the Transmitter/Sender Unit.
2. Connect the monitor to the Receiver Unit with an HDMI cable.
NOTE: IF the source has HDCP, the monitor must support HDCP.
3. Connect transmitter and receivers to the desired network with a Layer 2/3 IGMP
switch using CATx cables.
4. Set matching TX/RX to the same rotary position (see Section 4.1, Basic
Configuration).
5. Apply the proper power to all connecting devices.
6. Monitors connected to receiver units will show IP address before connecting.
NOTE: Figure 3-1 shows this installation.