Black & Decker BDBN1200 Nail Gun User Manual


 
9
There are two drive positions:
1. To drive the nail shallower, press the depth lock button and slide the depth
adjustment bar to the forward position. Release the depth lock button.
2. To sink a nail deeper, press the depth lock button and slide the depth adjustment bar
to the full rear position. Release the depth lock button.
Clearing a Jammed Nail (Figure 4)
If a nail becomes jammed in the nosepiece, keep the tool
pointed away from you and follow these instructions to clear:
1. Engage lock off.
2. Disconnect battery.
3. Release pusher from behind nails.
4. Pull up on latch then pull up to open front door.
5. Remove bent nail, using pliers if necessary.
6. If driver blade is in the down position, insert screwdriver
or other rod into nosepiece and push driver blade back in
position.
7. Remove rod and close front door.
8. Lift latch to engage wire and pull back to lock in place.
9. Reinsert nails into magazine (see Loading the Tool).
10. Push magazine closed until it locks in place.
Maintenance
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service organizations, always using identical
replacement parts.
The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling Corporation)
Seal on the nickel-cadmium battery (or battery pack) indicates that the
costs to recycle the battery (or battery pack) at the end of its useful life
have already been paid by Black & Decker. In some areas, it is illegal to place spent
nickel-cadmium batteries in the trash or municipal solid waste stream and the RBRC
program provides an environmentally conscious alternative.
RBRC in cooperation with Black & Decker and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent nickel-
cadmium batteries. Help protect our environment and conserve natural resources by
returning the spent nickel-cadmium battery to an authorized Black & Decker service
center or to your local retailer for recycling. You may also contact your local recycling
center for information on where to drop off the spent battery, or call 1-800-8-BATTERY.
Accessories
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNING: The use of any accessory not recommended for use with this tool could
be hazardous.
4
625779-00 BDBN1200Booklet 8/9/04 9:55 AM Page 9