Black & Decker BDCD220IA Impact Driver User Manual


  Open as PDF
of 84
 
QUICK RELEASE CHUCK (FIG. H)
NOTE: The chuck accepts 1/4 inch (6.35 mm) hex
accessories only.
WARNING: Remove battery pack before
changing accessories.
To install an accessory, pull the chuck collar (3)
away from the front of the tool, insert the accessory,
and release the collar. The accessory is locked in
place.
To remove an accessory, pull the chuck collar
(3) away from the front of the tool, remove the
accessory and release the collar.
ON BOARD BIT STORAGE
A bit storage slot is built-in to the area on the top of
the drill.
TROUBLESHOOTING
Problem Possible Cause Possible Solution
•Unitwillnotstart. •Batterypacknotinstalled •Checkbatterypack
properly. installation.
•Batterypacknotcharged. •Checkbatterypackcharging
requirements.
•Batterypackwillnot •Batterypacknotinsertedinto •Insertbatterypackinto
charge. charger. charger until green LED appears.
•Chargernotpluggedin. •Plugchargerintoaworking
outlet. Refer to “Important Charging
Notes” for more details.
•Surroundingairtemperature •Movechargerandbattery
too hot or too cold. pack to a surrounding air temperature of
above 40 degrees F (4.5°C) or below
105 degrees F (+40.5°C).
•Unitshutsoffabruptly. •Batterypackhasreachedits •Allowbatterypacktocool
maximum thermal limit. down.
•Outofcharge.(To •Placeonchargerand
maximize the life of the allow to charge.
battery pack it is designed
to shutoff abruptly when
the charge is depleted.)
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
MAINTENANCE
9
G
5
H
3
 previous next