Black & Decker BDCMTJSR Router User Manual


  Open as PDF
of 24
 
OPERATING INSTRUCTIONS
WARNING: Shock hazard.
WARNING: To reduce the risk of injury, turn off and remove battery from tool or
disconnect plug from power source before making any adjustments or removing or
installing attachments or accessories.
WARNING: Risk of lacerations or burns.


NOTE: 

OPERATION
 

 
NOTE: 
NOTE: 

INSTALLING AND REMOVING A ROUTER BIT
WARNING:To reduce the risk of injury, turn off and remove battery from tool or
disconnect plug from power source before making any adjustments or removing or
installing attachments or changing bits. Failure to do so could result in accidental starting
and possible injury.
BIT INSTALLATION AND REMOVAL (FIG. B)
NOTES:
 ROUTER IS NOT RECOMMENDED FOR USE WITH RAISED PANEL BITS.
 ROUTER IS NOT RECOMMENDED FOR USE IN METAL CUTTING APPLICATIONS.
 DO NOT USE ANY ROUTER BIT GREATER THAN 1-3/8” DIAMETER. USE PILOT
(BALL BEARING) ROUTER BITS FOR EDGE PROFILE CUTTING.
CAUTION:ROUTER BITS ARE SHARP, USE CARE WHEN HANDLING THEM.
INSTALLING BITS
WARNING: Turn the router off and remove
battery from tool or disconnect plug from power
source.



gure B

 

 
 

 


 

NOTE: If the router base is set at its maximum depth, the collet nut cannot be tightened
properly. Always insure that if the router base is adjusted to its maximum depth it must be
backed off several rotations (counterclockwise) before tightening or loosening router bits.
See “Setting the Router Depth” below for router base adjustment.
Spindle lock button
B
 previous next