Filter
Top Products
13
Fig. 22
L
B
H
C
Fig. 18
Fig. 21Fig. 20
Fig. 19
3. Locate the 1/4-20x2 inch hex head screw (G) Fig. 18. Place the 1/4 inch internal tooth lockwasher (O) M6.4 flat
washer (P) and the 1/4 inch external tooth lockwasher (R) on the screw (G).
4. Position the recessed end (E) Fig. 19 of the splitter bracket (B) against the end of the pivot rod (F), and fasten
using the assembly in STEP 3. NOTE: Do not completely tighten screw (G) at this time. Assembly shown in
Fig. 20.
NOTE: Loosely tighten the hardware for further adjustment.
5. Position the splitter (H) Fig. 21 against the splitter support bracket, making certain the two protrusions (K) on the
splitter support bracket are inside the slot of splitter (H).
R
P
O
G
F
E
G
B
K
H
6. Attach the splitter (H) Fig. 22 to the splitter support
bracket (B). Place a 1/4 inch external tooth
lockwasher and an M6.4 flat washer on an
M6x1x20mm hex head screw (L).
7. Insert the screw (L) Fig. 22 through the splitter
support bracket (C) and the splitter (H). Place an
M6.4 flat washer and a 1/4 inch external tooth lock
washer on the screw (L). Thread an M6x1 wing nut
(M) Fig. 23 on the screw (L) Fig. 23.