Filter
Top Products
Safety instructions
When using Power Tools, always observe the safety
regulations applicable in your country to reduce the
risk of fire, electric shock and personal injury. Read
the following safety instructions before attempting
to operate this product.
Keep these instructions in a safe place!
General
1 Keep work area clean
Cluttered areas and benches can cause accidents.
2 Consider work area environment
Do not expose Power Tools to humidity. Keep work
area well lit. Do not use Power Tools in the presence
of flammable liquids or gases.
3 Guard against electric shock
Prevent body contact with earthed surfaces (e.g.
pipes, radiators, cookers and refrigerators). For use
under extreme conditions (e.g. high humidity, when
metal swarf is being produced, etc.) electric safety
can be improved by inserting an isolating trans-
former or a (FI) earth-leakage circuit-breaker.
4 Keep children away
Do not let children or visitors come into contact with
the tool or extension cord. Supervision is required for
those under 16 years of age.
5 Extension cords for outdoor use
When the tool is used outdoors, always use exten-
sion cords intended for outdoor use and marked
accordingly.
6 Store idle tools
When not in use, Power Tools must be stored in a
dry place and locked up securely, out of reach of
children.
7Dress properly
Do not wear loose clothing or jewellery. They can be
caught in moving parts. Preferably wear rubber
gloves and non-slip footwear when working out-
doors. Wear protective hair covering to keep long
hair out of the way.
8Wear safety goggles
Also use a face or dust mask in case the operations
produce dust or flying particles.
9 Beware of maximum sound pressure
Take appropriate measures for the protection of
hearing if the sound pressure of 85 dB(A) is exceeded.
10 Secure workpiece
Use clamps or a vice to hold the workpiece. It is
safer and it frees both hands to operate the tool.
11 Do not overreach
Keep proper footing and balance at all times.
12 Avoid unintentional starting
Do not carry the plugged-in tool with a finger on the
switch. Be sure that the switch is released when
plugging in.
13 Stay alert
Watch what you are doing. Use common sense.
Do not operate the tool when you are tired.
14 Disconnect tool
Shut off power and wait for the tool to come to a
complete standstill before leaving it unattended.
Unplug the tool when not in use, before servicing or
changing accessories.
15 Remove adjusting keys and wrenches
Always check that adjusting keys and wrenches
are removed from the tool before operating the
tool.
16 Use appropriate tool
The intended use is described in this instruction
manual. Do not force small tools or attachments to
do the job of a heavy-duty tool. The tool will do the
job better and safer at the rate for which it was
intended. Warning! The use of any accessory or
attachment or performance of any operation with
this tool, other than those recommended in this
instruction manual may present a risk of personal
injury.
17 Do not abuse cord
Never carry the tool by its cord or pull it to discon-
nect from the socket. Keep the cord away from
heat, oil and sharp edges.
18 Maintain tools with care
Keep the tools in good condition and clean for bet-
ter and safer performance. Follow the instructions
for maintenance and changing accessories.
Inspect the tool cords at regular intervals and, if
damaged, have them repaired by an authorized
DeWALT repair agent. Inspect the extension cords
periodically and replace them if damaged. Keep all
controls dry, clean and free from oil and grease.
19 Check for damaged parts
Before using the tool, carefully check it for damage
to ensure that it will operate properly and perform
ENGLISH
5