Filter
Top Products
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
Motor
Your tool is powered by a DEWALT built motor designed to be used with
alternating current. Voltage decrease of more than 10% will cause
loss of power and overheating. All D
EWALT tools are factory tested; if
this tool does not operate, check the power supply.
Side Handle and Depth Rod
For operating convenience, the side handle can be installed in front or
rear positions. Always operate the tool with the side handle properly
assembled to maximize control of the tool.
TO MOUNT IN FRONT POSITION (FIG. 1)
1. Unscrew the side handle and
disassemble the side handle clamp.
2. Snap the steel ring over the collar
behind the tool holder. Squeeze both
ends together, mount the bushing
and insert the pin.
3. Place the side handle clamp and
screw on the clamp knob. Do not
tighten.
4. Insert adjustable depth rod into hole.
5. Screw the side handle into the clamp
knob and tighten it.
6. Rotate the side handle mounting
assembly to the desired position. For
drilling horizontally with a heavy drill bit, place the side handle
assembly at an angle of approximately 20˚ to the tool for optimum
control.
7. Lock the side handle mounting assembly in place by tightening the
clamp knob.
TO MOUNT IN REAR POSITION (FIG. 2)
1. Unscrew the side handle and remove it from the front position.
4
English
a. Tool Holder
b. Depth Rod
c. Side Handle
d. Clamp Knob
e. Alternate Side
Handle Location
f. Trigger Switch
g. Speed Dial
h. Mode Selector
i. Locking Sleeve
j. Retaining Pin
Button
k. Depth Rod
Clamp Nut
l. Steel Ring
m. Service LED
A
B
C
D
E
F
A
B
C
D
E
F
MODEL D25550
MODEL D25500
G
G
H
J
I
K
K
L
L
M
M
582429-00/D25500 etc 1/29/03 9:29 AM Page 4