Filter
Top Products
dangerous and must be repaired.
c. Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments,
changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these
instructions to operate the power tool. Power tools are dangerous in the hands of untrained users.
e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may
affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly
maintained power tools.
f. Use the power tool, accessories and tool bits etc., in accordance with these instructions, taking into account the working
conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous
situation.
5. Service
a. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the
safety of the power tool is maintained.
6. Electrical safety
Your tool is double insulated; therefore no earth wire is required.
Always check that the main voltage corresponds to the voltage on the rating plate.
Warning! If the power cord is damaged, it must be replaced by the manufacturer, authorized Black & Decker Service Center or an equally
qualified person in order to avoid damage or injury. If the power cord is replaced by an equally qualified person, but not authorized by
Black & Decker, the warranty will not be valid.
7. Labels on Tool
The label on your tool may include the following symbols:
• Use the guard and ensure it is fitted correctly.
• Check mounting flanges and the disc are correctly fitted and are undamaged.
• Ensure you are using the correct size and type of disc for the task.
• Ensure the disc, wire brush and sanding accessories are rated in excess of the spindle rpm of your angle grinder. Allow a newly assembled
wheel to idle off-load for 30 seconds before starting any operation.
FEATURES (FIG. 1)
OPERATING YOUR ANGLE GRINDER (FIG. 1)
To switch on, push the slider switch forward. To switch off, press the rear of the slider switch.
FITTING THE DISCS (FIG. 2 & 3)
Proceed as follows:
• Disconnect the plug from the electricity supply.
• Ensure the guard is fitted. Place the inner flange (Fig. 2-A) on the spindle. Ensure it is located on the two flats.
• Place the abrasive disc on the spindle and inner flange (Fig 2-B). Ensure it is correctly located.
• Fit the threaded outer flange (Fig. 2-C), making sure it is facing in the correct direction for the type of disc fitted. For grinding discs, the flange
(Fig. 2-C) is fitted with the raised portion facing towards the disc. For cutting discs, the flange (Fig. 2-C) is fitted with the inner portion facing
away from the disc.
• Hold the spanner on the flats of the spindle to prevent rotation of the disc and tighten the outer flange with the spanner provided.
1. Slider switch
2. Cable
3. Tool free guard
4. Body grip
5. Side handle (3 positions)
6. Spindle lock button
AADDDDIITTIIOONNAALL SSAAFFEETTYY IINNSSTTRRUUCCTTIIOONNSS FFOORR SSMMAALLLL AANNGGLLEE GGRRIINNDDEERRSS
Read Instructions Manual
Use Eye Protection
Use Ear Protection
V ........... Volts
A ........... Amperes
Hz ......... Hertz
W........... Watts
min........ minutes
........ Alternating Current
........ Direct Current
n
0
.......... No-Load Speed
........ Class II Construction
........ Earthing Terminal
........ Safety Alert Symbol
.../min.... Revolutions or Reciprocation
per minute
ENGLISH
13