Black & Decker MS800B Cordless Sander User Manual


  Open as PDF
of 28
 
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment should be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
A
ACCESSORIES
A variety of Mouse
®
accessories are available at extra cost. Listings per retailer may vary.
Note: Use only sandpaper with holes in the same configuration as on the base of the
8
• Pushtheotherendofthecontoursandingpieceuntilitclicksintoplace.
• To remove the contour sanding piece, push it forward then pull the rear end out of
the contour holder (g. 7).
Fitting a Sanding Sheet Onto a Contour Sanding Piece (Fig. 8)
• Alignthesandingsheetwiththecontoursandingpiece.
• Pressthesandingsheetontothecontoursandingpiece,making
sure that the sanding sheet follows the shape of the profile.
Dust Extraction (Fig. 9)
To Empty Dust Canister:
• Thedustcanistershouldbeemptiedafterevery10minutesofsanding.
• Whileholdingthesander,graspthedustcollectioncanisterandpulloffofthesander.
• Removethecanisterdoorandgentlyshakeortapthecanisteranddoortoempty.
• Re-attachthedoorandfirmlypushthecanisterbackontothesander.
CAUTION: Respiratory hazard. Never operate this tool for wood sanding unless
the dust canister is in place. Sanding dust exhaust may create a breathing hazard.
WARNING: Fire hazard. Collected sanding dust from sanding surface coatings
(polyurethane, linseed oil, etc.) can self-ignite in sander dust canister or elsewhere and
cause fire. To reduce risk, empty canister frequently and strictly follow sander manual and
coating manufacturer’s instructions.
WARNING: Fire hazard. When working on metal surfaces, do not use the dust canister
or a vacuum cleaner because sparks are generated. Wear safety glasses and a dust
mask. Due to the danger of fire, do not use your sander to sand magnesium surfaces. Do
not use for wet sanding.
TROUBLESHOOTING
Problem Possible Cause Possible Solution
• Unitwillnotstart. •Cordnotpluggedin. •Plugtoolintoaworkingoutlet.
•Circuitfuseisblown. •Replacecircuitfuse.
(If the product repeatedly causes
the circuit fuse to blow, discontinue
use immediately and have it
serviced at a Black & Decker service
center or authorized servicer.)
•Circuitbreakeristripped. •Resetcircuitbreaker.(Ifthe
product repeatedly causes the
circuit breaker to trip, discontinue
use immediately and have it
serviced at a Black & Decker service
center or authorized servicer.)
•Cordorswitchisdamaged. •Havecordorswitchreplacedat
Black & Decker Service Center or
Authorized Servicer.
• Dustisnot •Sandpaperholesdonotalign. •UseMouse
®
sandpaper with the
being collected. appropriate hole configuration.
For assistance with your product, visit our website www.blackanddecker.com for the
locationoftheservicecenternearestyouorcalltheBLACK&DECKERhelplineat
1-800-544-6986.
 previous next