Filter
Top Products
4
Operating Instructions
ATTACHMENT FOR USE WITH DREMEL
HIGH SPEED ROTARY TOOL MODELS
275, 285, 395, & 398.
ATTENTION: This attachment will convert
Dremel Rotary Tool to a Plunge Router for
freehand routing, edging, grooving, and
circular cuts. The router attachment comes
assembled ready for freehand or pilot bit
routing.
This Router Attachment is
not intended for use
under a router or saw table.
!
WARNING
Inserting the Router Bit
The router bits are held in the tool by a
collet system. The bit may be installed
before or after the rotary tool is installed
in the attachment.
1. Depress and hold the shaft lock button
while rotating the collet nut and shaft.
Continue to rotate the collet nut and
shaft until the lock engages and holds
the shaft (Fig. 4).
2. Use the wrench from your Dremel Rotary
Tool and turn the collet nut counter-
clockwise to loosen it.
3. Release the shaft lock button.
4. Insert the router bit into the collet as
deep as possible to ensure proper grip-
ping of the bit and to minimize run out.
Do not insert the bit so far that bit flutes
touch the collet or collet nut to avoid
chipping or cracking the bit.
NOTE: Never place the tool with bit
protruding through base on top of bench or
work surface. Lay the tool on its side or
retract the bit before setting on bench or
work surface. Protruding cutting bit may
cause tool to jump.
5. Re-engage the shaft lock button and
tighten the collet nut; first by hand, then
using the wrench until bit is held securely.
Shaft Lock
Button
Collet Nut
Wrench
Collet Nut
Base
FIG. 4
DM 2610920458 2-04 2/19/04 12:29 PM Page 4