Filter
Top Products
-10-
<366381986C <3663812+77/<381 &+<3969-5 +77/<381986C
used for drilling used for drilling allows for 36 desired used for light
wood, steel, etc. concrete positions of “hammer” chipping work
FIG. 5
#$ "
The selector dial allows the tool to be set for
various drilling/hammer drilling applications.
Depress release button and turn selector dial
right or left depending on the below
applications (Fig. 5).
When using demolition or chipping bits such
as bull points, chisels, spades, gouges, etc.
the “Hammer Only” mode must be selected.
9 89> 9:/<+>/ >2/
=/6/->398.3+6?8>36>2/>996
-97/>9+-97:6/>/=>9: Shifting during
rotation of the chuck can cause damage to the
tool.
#$ "F&" G
Adjusting the Vario-Lock: The vario-lock can
be set in any one of thirty-six (10˚ increments)
positions. Choose a position which is best
suited for your operation.
Depress release button and turn the selector
dial, to the “vario-lock” setting. Next, rotate
the locking sleeve, along with the accessory,
to the desired position. Then turn the selector
dial to the “hammer only” setting and slightly
turn the locking sleeve to have it automatically
lock into a definite position.
%(")
The tool must be supported with the auxiliary
handle, which can be swiveled 360˚. To
reposition and/or swivel the handle, loosen
the hand grip, move the handle to the
desired position along the barrel and
securely retighten the hand grip (Fig. 6).
!$%
Your drilling depth can be pre-set and/or
repeated by using the depth gauge.
Setting depth: After the auxiliary handle is
installed, make sure the accessory has been
fully inserted into the tool holder before
setting the depth gauge (Fig. 7).
To adjust depth, push the depth gauge
release button, slide the depth gauge to
desired depth and release pressure on
button to lock the depth gauge in place.
!
CAUTION
"!
!$%
"#
%$$
!$%
FIG. 6
FIG. 7
BM 1619929701 07-09:BM 1619929701 07-09 7/22/09 7:06 AM Page 10