Filter
Top Products
ADJUSTING THE ANGLE INDICATOR
If necessary, the position of the angle indicator
can be re-adjusted.
Loosen the screws on the underside of the
miter table attachment (approx. 1/2 turn). Also
loosen the preset angle release button and
locking screw if necessary. Align the saw
blade of the mounted saw with the aid of a
protractor or square to achieve the 0º setting.
Tighten the thumbscrew to secure setting, then
securely tighten the screws on the underside
of the table attachment (Fig. 11).
ALIGNING SAW BLADE 90º
TO THE MITER TABLE ATTACHMENT
If necessary, the blade can be re-aligned to be
90º to the table. First, loosen the thumbscrew.
Then align the saw blade of the mounted saw
with the aid of a square. Rotate the blade
alignment screw clockwise or counter-
clockwise until you achieve the 90 degree
setting. Then tighten the thumbscrew (Fig. 12).
DUST EXTRACTION
The miter table attachment is equipped with a
dust port for dust extraction. To use this
feature, attach a vacuum hose (optional
accessory) to the dust port, and then attach
opposite end to a shop vacuum cleaner (Fig.
13).
-10-
FIG. 11
FIG. 13
ANGLE
INDICATOR
ADJUSTMENT
SCREWS
LOCKING
SCREW
BLADE ALIGNMENT
SCREW
FIG. 12
DUST
PORT