Filter
Top Products
-10-
##'$ '(&'!"'
The footplate tilts in order to keep as much of
its surface in contact with the work surface
(Fig. 4) . To adjust, hold saw firmly and pivot
footplate to desired position.
&*##
Your tool is equipped with a convenient saw
hook for hanging your tool. To use, simply lift
up hook until it snaps into the open position
(Fig. 5).
*52;B@6;4A52@.D5<<8
.9D.F@/2.D.?2A5.AA52
.002@@<?F6@2E=<@21 Always hang the tool
in an area where yourself and bystandards can
not accidently make contact with the
accessory.
'<?21B02A52?6@8<36;7B?FB@20.?26;
@2920A6;4A529<0.A6<;3<?5.;46;4A52A<<9
• Select a suitably sized and shaped object
that will provide adequate hanging stability.
An unstable hanging surface could result in
the tool unexpectedly falling.
• Insure that the tool is hung out of the way of
walkways and working areas with bystanders.
The tool could be bumped or a bystander
could become entangled causing the tool to
unexpectedly fall.
'<?21B02A52?6@8<36;7B?F
< ;<A B@2 A52 5.;46;4
5<<8636A.==2.?@1.:.421<?123<?:21
This could result in unstable hanging and the
tool unexpectedly falling.
When not in use, always close hook until it
snaps into the closed position.
!
WARNING
!
WARNING
PIVOTING
FOOTPLATE
FIG. 4
FIG. 5
SAW HOOK
(@6;4A52&.D
1. Securely clamp the work.
2. Mark the line of cut and grasp the tool with
one hand on the handle and the other
placed on the insulated rubber boot over
the front housing.
9D.F@<=2?.A2A52@.D
D6A5A526;@B9.A21/<<A<;
A523?<;A5<B@6;4 If you saw into a blind area
where live wiring exists, you may be shocked
or electrocuted.
3. Keep the saw footplate firmly against the
work to minimize counter-force (jumping)
and vibration.
4. Squeeze the trigger to start the tool. Let the
saw reach full speed before starting the cut.
Guide the saw so that the blade will move
along the marked line.
&*"'$&
Following a few simple tips will reduce the
wear on the workpiece, the tool and the
operator.
1. Blades cut on the draw or back stroke. On
fine work, such as paneling, fiberglass, etc.,
place the good side of workpiece facing
down.
2. Use the correct saw blade for the material
being cut and keep extra blades on hand to
!
WARNING
BM 2610027769 09-12_BM 2610027769 09-12.qxp 9/12/12 2:33 PM Page 10