Filter
Top Products
-18-
charge battery packs before using after
prolonged storage.
T
OOL LUBRICATION
Y
our Bosch tool has been properly lubricated
and is ready for use.
D.C. MOTORS
The motor in your tool has been engineered
for many hours of dependable service. To
maintain peak efficiency of the motor, we
recommend it be examined every six months.
Only a genuine Bosch replacement motor
specially designed for your tool should be
used.
BEARINGS
Bearings which become noisy (due to heavy
load or very abrasive material cutting) should
be replaced at once to avoid overheating and
motor failure.
Cleaning
To avoid accidents, always
disconnect the tool and/or
charger from the power supply before
cleaning.
The tool may be cleaned most
effectively with compressed dry air.
Always
wear safety goggles when cleaning tools
with compressed air.
Ventilation openings and switch levers must be
kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects
through opening.
Certain cleaning agents and
solvents damage plastic
parts.
Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents,
ammonia and household detergents that
contain ammonia.
!
WARNING
!
CAUTION
If an extension cord is
necessary, a cord with
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used.
This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-wire
extension cords that have 3-prong plugs and
receptacles.
NOTE: The smaller the gauge number, the
heavier the cord.
RECOMMENDED SIZES OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
!
WARNING
Accessories
Tool’s
Ampere
Rating
Cord Size in A.W.G.
Wire Sizes in mm
2
3-6
6-8
8-10
10-12
12-16
18
16
16 14 0.75 0.75 1.5 2.5
18 16 14 12
0.75
1.0 2.5 4.0
18 16
14
12 0.75 1.0 2.5 4.0
16
16 14 12 1.0 2.5 4.0 —
14 12 — — ————
25 50 100 150 15 30 60 120
Cord Length in Feet Cord Length in Meters
(*= standard equipment)
(**= optional accessories)
**
15 minute charger
** 30 minute charger (single bay)
** 30 minute charger (dual bay)
** 1 hour charger
* rip fence
* 5-3/8" thin kerf 18 tooth carbide blade
**
5-3/8
" thin kerf 24 tooth carbide blade
** 15 foot “Airsweep” hose, attaches to most
vacuum cleaners
BM 2610925945 6-05 6/10/05 10:30 AM Page 18