Filter
Top Products
-12-
4. If battery does not charge properly:
a. Check for voltage at outlet by plugging
in some other electrical device.
b. Check to see if outlet is connected to a
l
ight switch which turns power “off”
when lights are turned off.
c. Check battery pack terminals for dirt.
Clean with cotton swab and alcohol if
necessary.
d. If you still do not get proper charging,
take or send tool, battery pack and
charger to your local Bosch Service
Center. See “Tools, Electric” in the
Yellow Pages for names and
addresses.
Note: Use of chargers or battery packs not
sold by Bosch will void the warranty.
CHARGING BATTERY PACK (BC830 1 HOUR CHARGER)
Plug charger cord into your standard power
outlet, then insert battery pack into charger
(Fig. 7).
The charger’s green indicator light will begin to
“BLINK”. This indicates that the battery is
receiving a fast charge. Fast-charging will
automatically stop when the battery pack is
fully charged.
When the unit beeps and the indicator light
stops “BLINKING” (and becomes a steady
green light) fast charging is complete.
The battery pack may be used even though
the light may still be blinking. The light may
require more time to stop blinking depending
on temperature. When you begin the charging
process of the battery pack, a steady red light
could also mean the battery pack is too hot or
too cold.
The purpose of the green light is to indicate
that the battery pack is fast-charging. It does
not indicate the exact point of full charge. The
light will stop blinking in less time if the battery
pack was not completely discharged.
When needed, the internal fan of the charger
will turn on to aid the charging process and
speed.
When charging several batteries in sequence,
the charge time may slightly increase.
When the battery pack is fully charged, unplug
the charger (unless you're charging another
battery pack) and slip the battery pack back
into the tool.
BATTERY PACK
CHARGER
RED LIGHT
GREEN LIGHT
FIG. 7
BM 2610944508 11-06 12/1/06 3:29 PM Page 12