Bosch Power Tools CCS180BN Battery Charger User Manual


 
! *&!%"! "$
%"' !"&  '%
'!%%%"'&+!%%$+Use
of improper extension cord could result in risk
of fire and electrical shock. If an extension cord
is used, make sure:
,The pins on plug of extension cord are the
same number, size, and shape as those of plug
on charger.
-The extension cord is properly wired and in
good electrical condition.
.The wire size is large enough for AC ampere
rating of charger as specified below:
/An extension cord is a temporary solution.
Move the charger to a standard receptacle as
soon as the job has been completed.
Length of
Cord, Feet
25 50 100 150
AWG Size
of Cord
18 16 16 14
Extension Cord Chart for 220/240 Volt Tools:
0.75mm
2
CORD 50 Meters
1.0mm
2
CORD 75 Meters
If the indicator lights are “OFF”, the charger is
not receiving power from power supply outlet.
If the green indicator light is “ON”,
the charger is plugged in but the
battery pack is not inserted, or the
battery pack is fully charged.
If the green indicator light is
“BLINKING”, the battery pack is
being fast-charged. Fast-charging
will automatically stop when the battery pack is
fully charged.
If the red indicator light is “ON”,
the battery pack is too hot or cold
for fast-charging. The charger will
automatically switch to fast-charging once a
suitable temperature is reached.
If the red indicator light is
“BLINKING”, the battery pack
cannot accept a charge or the
contacts of the charger or battery pack are
contaminated. Clean the contacts of the
charger or battery pack only as directed in
these operating instructions or those supplied
with your tool or battery pack.
-4-
:9:?,??08;??:/4>,>
>08-70 ?30 -,??0=D :=
=08:A0,9D.:8;:909?;=:50.?4921=:8?30
-,??0=D?0=849,7> Fire or injury may result.
Prior to disposal, protect exposed terminals
w
ith heavy insulating tape to prevent shorting.
4?34@84:9,??0=40>
If equipped with a lithium-ion battery, the
battery must be collected, recycled or disposed
of in an environ mentally sound manner.
“The EPA certified RBRC Battery
Recycling Seal on the lithium-ion
(Li-ion) battery indicates Robert
Bosch Tool Corporation is
voluntarily participating in an
industry program to collect and recycle these
batteries at the end of their useful life, when
taken out of service in the United States or
Canada. The RBRC program provides a
convenient alterative to placing used Li-ion
b
atteries into the trash or the munici pal waste
stream, which may be illegal in your area.
Please call 1-800-8-BATTERY for information
on Li-ion battery recycling and disposal
bans/restrictions in your area, or return your
batteries to a Skil/Bosch/Dremel Service
Center for recycling. Robert Bosch Tool
Corporation’s involvement in this program is
part of our commitment to preserving our
environment and conserving our natural
resources.”
!
WARNING
!
WARNING
,??0=D4>;:>,7
C?09>4:9:=/>
The battery is supplied partially charged.
Completely charge the battery before using your
cordless screwdriver for the first time. The lithium
ion battery can be charged at any time, without
reducing its service life. Interrupting the charging
procedure does not damage the battery.
3,=20=9/4.,?:=>>D8-:7>,9/80,94928:/07
";0=,?4929>?=@.?4:9>
BM 2610033301 10-13_BC630 10/11/13 10:52 AM Page 4