Filter
Top Products
-13-
Plug charger cord into your standard power
outlet.
With no battery pack inserted, the charger’s
green indicator light will go ON. This indicates
t
he charger is receiving power and the charger
is ready for operation.
When you insert the battery pack into the
charger. The charger’s green indicator light will
begin to “BLINK”. This indicates that the battery
is receiving a fast charge (Fig. 7).
When the indicator light stops “BLINKING” (and
becomes a steady green light) fast charging is
complete. The battery pack is fully charged and
can be removed from the charger.
The battery pack may be used even though the
light may still be blinking. The light may require
more time to stop blinking depending on
temperature.
The purpose of the green light is to indicate that
the battery pack is fast-charging. It does not
indicate the exact point of full charge. The light
will stop blinking in less time if the battery pack
was not completely discharged.
When you begin the charging process of the
battery pack, a steady red light could also
mean the battery pack is too hot or too cold.
Fast charging is only possible when the
temperature range of the battery pack is
between 32˚F (0˚C) and 113˚F (45˚C). When
needed, the internal fan of the charger will turn
on to aid the charging process and speed.
As soon as the battery pack reaches the
c
orrect temperature range, the battery charger
will automatically switch to fast charging.
If the red indicator light is “BLINKING”, the
battery pack cannot accept a charge.
• Check to make sure the battery pack is
inserted into the charger properly.
• Clean the contacts of the charger or battery
pack (e. g. by inserting and removing the
battery several times) or replace the battery
pack, as required.
When the battery pack is fully charged, unplug
the charger (unless you're charging another
battery pack) and slip the battery pack back into
the tool.
The manufacturer is not responsible for radio
interference caused by unauthorized
modifications to this equipment. Such
modifications could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful
interference, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
!& This equipment has been tested and
found to comply with the limits for a Class B
digital devices, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
BATTERY
PACK
CHARGER
RED
LIGHT
GREEN
LIGHT
$ &&$+";018
FIG. 7
-A@5;:
BM 2610027761 08-12_BM 2610027761 08-12.qxp 8/17/12 1:54 PM Page 13