Filter
Top Products
-9-
88*2'1>
.8(433*(9'&99*7>5&(0
+7429441'*+47*2&0.3,
&3>&88*2'1>&)/:892*39847(-&3,.3,
&((*8847.*8. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
Move reverse switch lever to the center “OFF”
position. Remove battery pack and rotate the
clutch ring to the drill bit symbol
“ ”. Rotate the chuck sleeve counter-
clockwise viewing from chuck end, and open
chuck to approximate drill bit diameter. Insert
a clean bit up to the drill bit flutes for small bits,
or as far as it will go for large bits. Close chuck
by rotating the chuck sleeve clockwise and
securely tighten by hand (Fig. 2).
4349:8*9-*54<*74+
9-*)7.11<-.1*,7&85.3,
(-:(0941448*3479.,-9*3'.9 Friction burn
or hand injury is possible if attempting to grasp
the spinning chuck.
!
WARNING
!
WARNING
CHUCK SLEEVE
FIG. 2
DRILL BIT
BIT HOLDER
SCREWDRIVER BIT
!$%
The tool must be supported with the auxiliary
handle, which can be swiveled 320˚. To
reposition and/or swivel the handle, loosen the
hand grip, move the handle to the desired
position along the barrel and securely retighten
the hand grip (Fig. 3 & 4).
3
1
2
1
FIG. 3
3
1
2
FIG. 4
!
Your drilling depth can be pre-set and/or
repeated by using the depth gauge.
Setting depth: After the auxiliary handle is
installed, slide the depth gauge to desired
depth and securely tighten wing knob (Fig. 5
& 6).
1
2
FIG. 5
X
3
FIG. 6
BM 2610032842 04-14_DDH181X HDH181X 4/9/14 7:10 AM Page 9