Bosch Power Tools DMD4 Stud Sensor User Manual


 
-11-
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC
Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit, different from that which the receiver is
connected (if applicable).
(4) Consult the dealer or an experienced radio/TV technician for help.
FCC Part 15 Class B Registration Warning
SPARE PARTS
Protective case 1 609 203 U05
Battery lid 1 609 203 W19
Felt pads
1 609 203 P21
DISPOSAL
Multi-detectors, accessories and packaging should be sorted for environmental-friendly
recycling.
BM 2609140574 08-08 9/3/08 8:40 AM Page 11