Filter
Top Products
-21-
13. As driver blade is inserted into blade
o
pening, align both guide rails into rail
holes on both sides (Fig. 27).
14. Securing driver sub-assembly to tool.
Frame assembly should align with
mounting holes for pins. Insert both pins
and push in (Fig. 28).
15. Pins should stick out an equal length from
b
oth sides (Fig. 29).
16 Place metal top cap back on tool. Replace
(3) allen screws (Fig. 30).
%0,!#).'2)6%2,!$%
1. Remove metal cap. Using 3mm hex
wrench, remove 3 screws and set aside
(Fig. 31).
2. Remove drive block pin #1 by pushing on
one side. Pull on other end to remove.
*TIP* 16ga finish nail can be used to slide
pin out (Fig. 32).
/2%0,!#%$2)6%",!$%&/,,/734%03"%,/7
FIG. 27
FIG. 28
FIG. 29
FIG. 30
FIG. 31
FIG. 32
BM 2610034445 03-14_FNH180 3/27/14 11:52 AM Page 21