Filter
Top Products
-10-
#
To insert battery, slide charged battery pack
into the housing until the battery pack locks
into position.
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward (Fig. 8).
82 mm
max
8 mm
max
FIG. 6
45°
FIG. 7
27( The deluxe fence must be attached to
the left side of the tool. (Fig. 1).
Installing the deluxe guide fence: Place the
wing knob through the appropriate hole in the
guide bracket and screw into left side of the
housing. Securely tighten wing knob. Setting
the cutting width: Place wing knob through the
left fence arm and slide along the guide
bracket to the desired position. Securely
tighten wing knob. Be certain that the flat
washer (supplied) is fitted between the bottom
of the guide fence and wing knob or the guide
fence is likely to slip.
Setting the cutting width: Loosen wing knob
and using the width scale, slide the fence
along the guide bracket to the desired
position. Securely tighten wing knob (Fig. 1).
Setting the cutting angle: Loosen round
knobs and pivot the fence to the desired
position. Securely tighten round knobs (Fig. 1).
Note that the adjustable front shoe contains
a chamfer V-groove, which will follow the
corner of a workpiece to allow easier
handling when using the deluxe angle/width
fence (Fig. 7).
The optional rabbeting depth stop accessory
(Fig. 1) allows the user to set any rabbeting
depth from 0 to 5/16 inch. For best results, it
is important that the blade be properly aligned
(See "BLADE ALIGNMENT"). The width of
the rabbet is controlled by the width fence.
The maximum cutting width is 3-1/4", and the
final depth is achieved by repetitive cutting
until the rabbeting depth guide contacts the
workpiece. The maximum rabbeting depth is
5/16"
Setting the rabbet depth: Loosen wing knob
and using the depth scale on the rabbeting
depth stop, set the desired rabbet depth.
Securely tighten wing knob.
BATTERY
PACK
RELEASE
BUTTON
BATTERY
PACK
FIG. 8
BM 2610034449 03-14_PLH181 3/27/14 12:52 PM Page 10