Filter
Top Products
-9-
Assembly
Disconnect battery pack
from tool before making
any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
INSERTING BITS
(Model PS32 only)
Move reverse switch lever to the center “OFF”
position. Remove battery pack and rotate the
clutch ring to the drill bit symbol
“ ”. Rotate the chuck sleeve counter-
clockwise viewing from chuck end, and open
chuck to approximate drill bit diameter. Insert
a clean bit up to the drill bit flutes for small bits,
or as far as it will go for large bits. Close chuck
by rotating the chuck sleeve clockwise and
securely tighten by hand (Fig. 3).
Do not use the power of the
drill while grasping chuck
to loosen or tighten bit. Friction burn or hand
injury is possible if attempting to grasp the
spinning chuck.
The Bosch model PS22 Cordless Drill/Driver
has a chuck that accepts any 1/4" hex bit.
INSERTING AND REMOVING ACCESSORIES
(Model PS22 only)
To avoid loss of control,
ensure bit is locked in chuck
by pulling on bit after it has been inserted.
To insert an accessory, simply pull locking
sleeve forward, insert desired accessory into
chuck until the locking sleeve retracts
automatically, locking the bit (Fig. 2).
To remove an accessory, pull locking sleeve
forward and simply remove it from the chuck.
One inch bits should only be used along
with a bit holder as shown in figure 2.
CHUCK
FIG. 4
LOCKING
SLEEVE
HEX-SHANK
DRILL BIT
SCREWDRIVER
BIT
BIT HOLDER
!
WARNING
CHUCK SLEEVE
FIG. 3
DRILL BIT
BIT HOLDER
SCREWDRIVER BIT
!
WARNING
!
WARNING
BELT CLIP AND BIT TIP HOLDER”
Both the PS22 and PS32 come with the option
of a metal belt clip and a four piece bit tip holder.
BELT CLIP
When the tool is attached to
the belt, position yourself to
avoid entanglement with surrounding objects.
Unexpected entanglement could cause the tool
to fall resulting in injury to the operator or
bystanders.
The belt clip will allow you to conveniently
attach your tool to your belt. This feature will
allow you to have both hands free when
climbing a ladder or moving to another work
area.
The belt clip can be attached to either side of
the tool by securing it with a mounting screw.
Always make sure you securely tighten the
mounting screw before use (Fig. 5).
To use clip, turn tool upside down and attach
to your belt.
!
WARNING
2610031969 09-13_2610031969 09-13.qxp 10/3/13 10:50 AM Page 9