Filter
Top Products
Operating Tips
-11-
GEAR SHIFTING
Your tool is equipped with two separate gear
ranges, low gear and high gear. Low gear
provides high-torque and slower drilling
speeds for heavy duty work or for driving
screws. High gear provides faster speeds for
drilling lighter work. To change speeds slide
switch, to the high or low position (Fig. 1).
ATTENTION: If your tool appears to be
running, but the chuck will not turn, check to
make sure the gear shifting switch is pushed
fully into desired setting.
ADJUSTABLE CLUTCH
Your tool features 21 clutch settings. Output
torque will increase as the clutch ring, is
rotated from 1 to 20. The drill “ ” position
will lock up the clutch to permit drilling and
driving heavy duty work (Fig. 1).
AUTOLOCK™
Your tool is equipped with an automatic locking
system. This feature will lock the bit holder in
one position when the trigger switch is
released. This will allow you to tighten or loosen
a nut or screw by rotating the tool by hand with
the switch off. This is convenient when higher
turning torque is needed.
BUILT IN WORK LIGHT
Your tool is also equipped with a light that turns
on automatically when the switch is activated,
for better visibility when drilling/driving (Fig. 1).
BATTERY CHARGE CONDITION
INDICATOR LIGHTS
Your tool is equipped with charge condition
indicator lights (Fig. 1). The indicator lights
shows the charge condition of the battery for a
few second when the On/Off trigger is pressed
halfway or fully.
Release battery pack from tool by pressing on
both sides of the battery release tabs and pull
downward (Fig. 8 or 9).
To insert battery, align battery and slide
battery pack into tool until it locks into position.
Do not force.
If battery release tabs are
cracked or otherwise
damaged, do not insert into tool. Battery can
fall out during operation.
!
WARNING
BATTERY
RELEASE
TABS
FIG. 8
LED Capacity
Continuous lighting 3 x green > 2/3
Continuous lighting 2 x green > 1/3
Continuous lighting 1 x green < 1/3
Flashing light 1 x green reserve
BATTERY
RELEASE
TABS
FIG. 9
INSERTING AND RELEASING BATTERY PACK
You will extend the life of your bits and do
neater work if you always put the bit in
contact with the work before pulling the
trigger. During the oper a tion, hold the tool
firmly and exert light, steady pressure. Too
much pressure at low speed will stall the tool.
Too little pressure will keep the bit from
cutting and cause excess friction by sliding
over the surface. This can be damaging to
both tool and bit.
2610031969 09-13_2610031969 09-13.qxp 10/3/13 10:50 AM Page 11