Filter
Top Products
Step 4: Disconnect bulb wire from connector by holding the
connector firmly with fingers then pulling bulb wire
straight out as shown in Figure 2.
Step 5: Squeeze the wire retainer together and lift up as
illustrated in Figure 3.
Step 6: Pull bulb straight out from the reflector mounting plate.
Step 7: To install new bulb, grasp the bulb from the metal end
(DO NOT TOUCH THE GLASS PART) and insert into the
reflector mounting plate. Align the slots in the bulb base
with those in the reflector mounting plate.
Step 8: Replace wire retainer by squeezing ends together while
pressing down. Release ends so that they catch on the
reflector mounting plate.
Step 9: Reconnect the bulb wire to the connector as illustrated
in Figure 4.
Step 10: To reassemble spotlight, align screw holes in the rear
and front housings, then insert the rear housing into the
front housing of the spotlight.
Step 11: Replace the two screws that were removed in Step 2. Do
not overtighten screws.
Replacement bulbs and accessories may be purchased from
The Brinkmann Corporation Consumer Sales Department by
calling 1-800-468-5252.
3
Connector
Connector
FIGURE 3
FIGURE 4
FIGURE 2