Filter
Top Products
Step 5: Disconnect bulb wire from connector by holding the connector
firmly with fingers then pulling bulb wire straight out as shown
in Figure 2.
Step 6: Spread the wire retainer apart and lift up as illustrated in
Figure 3.
Step 7: Pull bulb straight out from the reflector mounting plate.
Step 8: To install new bulb, grasp the bulb from the metal end (DO NOT
TOUCH THE GLASS PART) and insert into the reflector
mounting plate. Align the slots in the bulb base with those in
the reflector mounting plate.
Step 9: Replace wire retainer by spreading ends apart while pressing
down. Push ends together so they catch on the reflector
mounting plate.
Step 10: Reconnect the bulb wire to the connector as illustrated in
Figure 4.
Step 11: To reassemble spotlight, leave the front housing face (lens)
down on a flat surface with the reflector in the front housing.
Insert the rear housing into the front housing of the spotlight.
Step 12: Replace the two screws that were removed in Step 2. Do not
over tighten screws.
3
2,000,000
CANDLEPOWER
Connector
0
0,000
LEPOWER
Connector
FIGURE 3
FIGURE 4
FIGURE 2
Replacement bulbs and accessories may be purchased from The Brinkmann
Corporation Consumer Sales Department by calling 1-800-468-5252.
800-2550-0_INSTR-MAXMILL2 7/10/02 11:49 AM Page 5