Filter
Top Products
15
1 Ensamblaje de la armazón del
rodillo, 20,32 cm (8”) AL227050SV 1
2 Ensamblaje de la armazón
del rodillo, 50,80 cm (20”) AL227550SV 1
3 Ensamblaje de soportes PP201900AJ 2
4 Separador PP016200AV 1
5 Lanilla de 10mm (3/8”) AL040401AV 1
6 Arandela AL009900AV 1
7 Perno ranurado ST071616AV 1
No. de
Ref. Descripción No. del Repuesto Ctd.
Sírvase suministrarnos la siguiente información:
-Número del modelo
-Número de serie (de haberlo)
-Descripción del repuesto según la lista de
repuestos
Puede escribirnos a:
The Campbell Group
Attn: Parts Department
100 Production Drive
Harrison, OH 45030
Operation (Continued)
3. Connect roller to gun and position at desired angle. Tighten
with wrench.
PRESSURE ADJUSTMENT
1. For units with a single prime/pressure control, turn
the control knob approximately one turn from the prime
position.
IMPORTANT: Very little pressure is required for rolling.
2. Set sprayers with separate pressure control at lowest pressure
which provides a steady flow of paint.
PAINT APPLICATION
1. Trigger gun until paint appears on roller.
2. Roll roller on wall until roller is saturated.
3. Begin painting and trigger often enough to keep rolling
smooth and effortless.
Maintenance
1. Remove the slotted bolt and pull the cover off.
www.chpower.com
Figure 2
End Caps
Roller
Cover
2
453401 1102 11/12/02 3:02 PM Page 2