Filter
Top Products
Operating Instructions and Parts Manual
8
Glossary
Become familiar with these terms before operating the unit.
ACTUATE (TOOL) — To cause movement to the tool’s component(s) intended to
drive the fastener.
ACTUATION SYSTEM — The use of a trigger, work contact element (WCE) and/
or other operating control, separately or in combination or sequence, to actuate
the tool.
AIR INLET — The opening in which the compressed air supply is connected,
usually by means of a threaded fitting.
FASTENERS — This tool uses 1 inch to 2-1/2 inch 15g 35° D-clipped head angle
finish nails.
MAGAZINE — The part of the nailer that holds the Fasteners.
MAXIMUM AIR PRESSURE — The maximum allowable pressure of compressed
air, as specified by the manufacture, for operating the tool.
NO-MAR / STUD FINDER TIP — The no-mar / stud finder tip is designed
to eliminate marks caused by the wire-form Work Contact Element (WCE).
The no-mar tip may be removed and tethered to the tool if not required (See
INSTALLING AND REMOVING NO-MAR / Stud finder TIP) or when a slightly
deeper countersink is preferred. Simply slide the no-mar off the WCE and attach
to the storage post on the magazine. The tip also functions as a convenient stud
finder. To utilize the no-mar / stud finder tip, simply slide it over the tools WCE
(see Figure 5).
psi (POUNDS PER SQUARE INCH) —Measurement of the pressure exerted by
the force of the air. The actual psi output is measured by a pressure gauge on the
compressor.
QUICK COUPLER — A quick coupler is designed to work in combination with a
quick plug to quickly and easily join a pneumatic tool to an air hose (see Figure 3).
QUICK PLUG — A quick plug is designed to work in combination with a quick
coupler to quickly and easily join a pneumatic tool to an air hose (see Figure 4).
REGULATOR — A device used to control air pressure to an air operated tool
THREAD LOCK GLUE — A locking glue that is applied to the screw threads
before installing. Prevents the screws from working loose during tool operation.
Figure 3 - Quick Coupler
Figure 4 - Quick Plug
Figure 5 - No-mar / Stud finder Tip
www.chpower.com
CHN70600