Filter
Top Products
26 Sp
Compresor lubricado con aceite
7
Troubleshooting Chart (Continued)
Symptom Possible Cause(s) Corrective Action
1. Loose drain valve
2. Check valve leaking
3. Loose connections at fittings, tubing,
etc.
4. Tank leaks
1. Excessive air usage, compressor too
small
2. Clogged intake filter
3. Loose connections at fittings, tubing,
etc.
4. Tank leaks
5. Broken valves
6. Piston ring worn
1. Excessive water in tank
2. High humidity
1. Defective pressure switch
2. Defective safety valve
1. Excessive condensation in tank
2. Loose connections at fittings, tubing,
etc.
3. Tank leaks
1. Check valve stuck in an open position
2. Unloader valve stuck in open position
3. Replace or repair as necessary.
1. Tighten.
2. Remove check valve. Clean or replace.
3. Check all connections with soap and water solution.
If a leak is detected, (1) tighten or (2) remove fitting
and apply pipe tape to threads and reassemble.
4. Check tank for leaks with soap and water solution. If
leak is detected, tank must be replaced with genuine
replacement part.
Do not disassemble check
valve with air in tank;
bleed tank
1. Decrease usage or purchase unit with higher air
delivery (SCFM).
2. Clean or replace.
3. Check all connections with soap and water solution.
If a leak is detected, (1) tighten or (2) remove fitting
and apply pipe tape to threads and reassemble.
4. Check tank for leaks with soap and water solution. If
leak is detected, tank must be replaced with genuine
replacement part.
5. Replace compressor valves as necessary.
6. Replace piston rings.
1. Drain tank.
2. Move to area of less humidity; use air line filter.
NOTE: Water condensation is not caused by
compressor malfunction.
1. Replace switch.
2. Replace safety valve with genuine replacement part.
1. Drain more often.
2. Check all connections with soap and water solution.
If a leak is detected, (1) tighten or (2) remove fitting
and apply pipe tape to threads and reassemble.
3. Check tank for leaks with soap and water solution. If
leak is detected, tank must be replaced with genuine
replacement part.
Do not disassemble check
valve with air in tank;
bleed tank
1. Repair or replace check valve.
2. Repair or replace unloader valve.
Do not disassemble check
valve with air in tank;
bleed tank
Tank pressure drops
when compressor shuts
off
Compressor runs
continuously and air
output is lower than
normal/low discharge
pressure
Excessive moisture in
discharge air
Compressor runs
continuously and safety
valve opens as pressure
rises
Excessive starting and
stopping (auto start)
Air leaking from
unloader valve on
pressure switch
HL5402
16
17
18
19
20
23
15
18
21
22
5
4
6
3
2
10
11
12
13
25
14
7
8
9
10
8
1
21
4
34
35
26
25
37
36
38
39
40
24
24a
25
26
33
32
28
29
30
31
27
41
42
43
44a
44b
44c
44d
44e
44
45
47
48
49
44f
46
51
50
70
71
72
69
68
52
67
66
65
52
53
54
55
56
57
56
55
58
59
60
61
63
64
61
62