Campbell Hausfeld IN715703AV Nail Gun User Manual


 
MODE CONVERSION
To convert the tool from one mode to
the other:
1. Remove o-ring on the side of trigger
pin.
2. Remove trigger pin, trigger, and
trigger spring.
3. Switch out only the trigger.
4. Replace trigger spring, trigger,
trigger pin, and o-ring.
Do not attempt to modify the trigger
components in any manner and do
not attempt to use any other trigger
components other than those intended
for this tool.
Contact your Campbell Hausfeld
representative if you have any
questions.
OPERATING A SEQUENTIAL TRIP TOOL
Check the operation
of the Work Contact
Element (WCE) trip mechanism before
each use. The WCE must move freely
without binding through its entire
travel distance. The WCE spring must
return the WCE to its fully extended
position after being depressed. Do
not operate the tool if the WCE trip
mechanism is not operating properly.
Personal injury may occur.
1. Disconnect the air
supply from the tool.
2. Remove all fasteners
from the magazine
(see Loading /
Unloading).
6
Operating Instructions
www.chpower.com
OPERATING INSTRUCTIONS
(Continued)
3. Make sure the trigger
and work contact
element (WCE) move
freely up and down
without sticking or
binding.
4. Reconnect air supply
to the tool.
5. Depress the Work
Contact Element
(WCE) against
the work surface
without pulling
the trigger. The
tool MUST NOT
OPERATE. Do not use the tool if it
operates without pulling the trigger.
Personal injury may result.
6. Remove the tool
from the work
surface. The
Work Contact
Element (WCE)
must return
to its original
down position. The tool MUST NOT
OPERATE. Do not use the tool if it
operates while lifted from the work
surface. Personal injury may result.
7. Pull the trigger
and depress the
work contact
element (WCE)
against the work surface. The tool
MUST NOT OPERATE IF IN SINGLE
CYCLE MODE (black trigger). The
tool MUST OPERATE IF IN BOTTOM
TRIP MODE (red trigger).
8. Depress the
Work Contact
Element (WCE)
against the
work surface.
Pull the trigger. The tool MUST
OPERATE.
An improperly
functioning tool
must not be used. Do not actuate the
tool unless the tool is placed firmly
against the work piece.
LOADING THE NAILER
1. Always disconnect the tool from
the air supply before loading
fasteners.
2. Pull nail pusher
mechanism back
until pusher
engages with
magazine latch.
3. Load strips of
fasteners into
the magazine
slot. Make sure
that the nails are
placed into tool
at the proper
orientation.
4. Squeeze the
pusher and the
latch together to
unlatch pusher.
Make sure the
head of the last
nail is under the
head of the pusher.
UNLOADING THE NAILER
1. Always unload all fasteners before
removing tool from service.
Unloading is the reverse of loading,
except always disconnect the air
hose before unloading.
2. Pull nail pusher
mechanism back
until pusher
engages with
magazine latch.
3. Hold tool upright
so nails will
slide backwards
toward magazine
slot.
4. Squeeze the
pusher and
latch together
to unlatch the
pusher once all
nails have been
removed.
Trigger spring
Trigger pin
Mode Conversion
O-ring
Trigger
®
Latch
Nail Pusher
Mechanism
®
Latch
Nail Pusher
Mechanism