5
Operating Instructions SB504000
www.chpower.com
Operating Instructions
(Continued)
OPERATIONAL MODE - SINGLE CYCLE
Always know the
operational mode of
the tool before using. Failure to know
the operational mode could result in
death or serious personal injury.
This tool requires the trigger to be
pulled each time a nail is driven. The
nailer can be actuated by depressing the
WCE against the work surface followed
by pulling the trigger.
The trigger must be released to reset
the tool before another nail can be
driven.
WORK CONTACT ELEMENT (WCE)
Check the operation
of the Work Contact
Element (WCE) trip mechanism before
each use. The WCE must move freely
without binding through its entire
travel distance. The WCE spring must
return the WCE to its fully extended
position after being depressed. Do
not operate the nailer if the WCE trip
mechanism is not operating properly.
Personal injury may occur.
1. Disconnect the air
supply from the tool.
2. Remove all fasteners
from the magazine
(see Loading/
Unloading).
3. Make sure the trigger
and work contact
element (WCE) move
freely up and down
without sticking or
binding.
4. Reconnect air supply
to the tool.
5. Depress the Work
Contact Element
(WCE) against the
work surface without
pulling the trigger.
The tool MUST NOT OPERATE.
Do not use the tool if it operates
without pulling the trigger. Personal
injury may result.
6. Remove the tool from
the work surface.
The Work Contact
Element (WCE) must
return to its original
down position. The tool MUST NOT
OPERATE. Do not use the tool if it
operates while lifted from the work
surface. Personal injury may result.
7. Pull the
trigger
and
depress
the work
contact
element (WCE) against the work
surface. The tool MUST NOT
OPERATE.
8. Depress
the Work
Contact
Element
(WCE)
against
the work surface. Pull the trigger.
The tool MUST OPERATE.
An improperly
functioning tool
must not be used. Do not actuate the
tool unless the tool is placed fi rmly
against the work piece.
LOADING/UNLOADING THE NAILER
1. Always disconnect the tool from the
air supply before loading fasteners.
2. Push
down on
the latch
button.
Pull back
on the
magazine
cover.
3a. For nails, insert a stick
of Campbell Hausfeld
nails or equivalent
(see “Fasteners”
section) into the
magazine. Make sure the pointed
ends of the fasteners are resting on
the bottom ledge of the magazine
when loading. Make sure the nails
are not dirty or damaged.
3b. For staples, load a clip
of staples with the
crowns straddling the
magazine rail.
4. Push the magazine
cover forward
until latch button
pops up.
5. Always unload all fasteners before
removing tool from service.
Unloading is the reverse of loading,
except that you must disconnect the
air supply before unloading.
ADJUSTING THE FASTENER
PENETRATION
The tool is equipped with an adjustable
depth of drive feature. This allows the
user to determine how deep a fastener
will be driven into the work surface.
1. Adjust operating pressure so nails
are driven consistently. Do not
exceed 120 psi.
2. To drive
the nail
shallower,
turn the
wheel (C)
to right to
the extent
desired.
3. To sink a nail
deeper, turn
the wheel
(C) to left to
the extent
desired.
4. Make sure trigger and work contact
element (WCE) move freely up and
down without binding or sticking
after each adjustment.
Latch
Button
Magazine Rail
(C)