Filter
Top Products
12
Airless Paint Sprayers
Operating Instructions and Assembly Instructions
Cleaning Hose and Gun
www.chpower.com
Turn Prime/ Spray
Control to SPRAY (knob
is vertical)
If Reversible Tip is
Used, Rotate Spray Tip
to CLEAN Position.
While Pulling Trigger,
Direct Fluid Stream Along
Inside of Bucket
9
10
CLEANUP FOR CHANGING PAINTS
OR TEMPORARY STORAGE FOR
MORE THAN ONE NIGHT
(Continued)
Allow the cleaning fluid to continue
circulating for approximately 10
minutes.
7. Turn pressure to HIGH (completely
clockwise).
8. Turn prime/spray control to SPRAY/
ROLL position.
9. If reversible tip is used, rotate spray
tip to CLEAN position.
10. Point spray gun into bucket of
paint and pull trigger.
NOTE: To reduce splashing, direct
fluid stream along inside of bucket
and above the paint level.
11. As soon as cleaning fluid is flowing
from spray gun, release trigger.
NOTE: It should take less than one
minute to clear each 25 feet of high
pressure hose.
12. Engage gun trigger lock.
13. Turn prime/spray control to PRIME
position.
14. Turn pressure control to HIGH.
15. Lift suction assembly above fluid
level in bucket.
NOTE: Allow pump to run until
empty.
16. Repeat process (1 - 15) with
fresh cleaning fluid, to remove
contaminated cleaning fluid from
initial cleaning.
Turn Pressure to HIGH
(completely clockwise).
7
8
Engage Gun Trigger Lock
12
PRIME Position
Lift Suction
Assembly
HIGH PRESSURE
Position
(completely clockwise)
12
Paint
To Lock Locked
13
14
15