Filter
Top Products
E-6
The Battery Charger can be used to charge the battery pack (DT-9723LIC).
1. Connect the power cable to the Battery
Charger, and then plug the cable into an
electrical outlet.
2. Attach the battery pack by sliding in the
direction indicated by the arrow. The
CHARGE indicator lamp (orange) lights
after a few seconds and charging begins.
Charging is completed when the CHARGE
indicator lamp goes out.
• Charging on completely discharged
battery pack takes about 3 hours.
• Time period of charging may vary
depending on the ambient temperature and condition of the battery pack.
• The CHARGE lamp flashes when battery pack already fully charged is attached
on the charger.
Important!
• Securely attach the battery pack to the Battery Charger.
• Charge the battery pack in a location that is free of vibrations.
• If the CHARGE lamp does not light at all or does flash when battery pack is
attached, it indicates the possibility of a malfunction either in the Battery Charger
or the battery pack. Please contact the store where you purchased the product or
an authorized CASIO service provider.
• Use only the power cord accompanied to the Battery Charger.
• For compliance in the USA and Canada, use only CSA/UL certified power cord
set, Polarized, Type SPT-2 or heavier, minimum No. 18 AWG copper, rated 125
or 250V, minimum 1A, minimum 6 ft (1.8m).
The power cord accompanied to the Battery Charger is compliant with this
requirement.
• With the Battery Charger, charge only the lithium-ion battery DT-9723LIC. It is
not recommended to use for other types of lithium-ion battery which may cause
burst.
Using the Battery Charger (DT-9721CHGE)
DT9721CHGE_E_P06_08.p65 09.11.12, 5:17 PM6