Central Pneumatic Air Compressor 97572 Staple Gun User Manual


 
SKU 97572
46365 Page 4
for the Air Compressor, it must be of the proper size and type to supply
the correct current to the tool without heating up. Otherwise, the extension
cord could melt and catch re, or cause electrical damage to the tool. If you
are using the tool outdoors, use an extension cord rated for outdoor use.
(signied by “WA” on the jacket).
21. Maintenance. For your safety, service and maintenance should be
performed regularly by a qualied technician.
Note: Performance of this tool (if powered by line voltage) may vary depending
on variations in local line voltage. Extension cord usage may also affect tool
performance.
Special Warnings for this Tool
It is especially important that you read and comply with the following safety
precautions.
1. Never, under any circumstances, press the tip of this tool against another
person or yourself.
2. Excess air may remain in the tool even after the tool is disconnected from the
air supply. For this reason, be especially careful never to carry this tool with
your nger on the trigger, and do not press the tip against any surface even
when the tool is not connected to an air supply.
3. While using this tool, be sure to keep ngers, hands and all other body parts
away from the tip of the tool.
4. Never use combustible gas as a power source.
5. Never use gasoline or other ammable liquids to clean the Stapler.
6. Do not exceed the maximum operating pressure of 95 PSI as stated in the
Specications Chart and warning label.
7. Ear protection is required for the operator and others in the work area.
8. Never attempt to drive staples on top of other staples.
9. Never attempt to keep the Trigger depressed with tape or wire.
10. Never leave the tool unattended or connected to the air supply when not in
use.
11. Do not throw the tool or use it as a hammer to knock material into place.
12. Avoid prolonged use of the Stapler, and do not use this tool if you have back,
neck or other bodily injuries that might be aggravated by the jerking motion
of the tool. Stop using this tool if you experience pain in your arms or hands.