Filter
Top Products
2
Test PIR Motion Sensor by waving hand in front of
sensor. Test light should flash. Secure cover with the
smallest screws.
Insert battery pack facing away from circuit board and
attach cover.
NOTE: Ensure the batteries do not touch the circuit
board and the antenna and battery wires are not
pinched.
PIR Sensor
Antenna
Switch #1:.
Switch #2:
ON
OFF
1
2
Step 4
Switch Settings
Switch #1
Switch #2
Test
Button
OFF Low Sensitivity
ON High Sensitivity
(Default)
OFF 15' Detection Range
ON 30' Detection Range
(Default)
NOTE: To avoid unwanted detection of small animals
move Switch #2 to OFF.
Step 3
PIR Motion Sensor Assembly
& Test
Attach PIR Motion Sensor box to mounting plate with
large silver screw. Tighten screw until PIR Motion
Sensor stays in place when repositioned.
Install 4 AA Alkaline batteries (not provided). (Lithium
batteries recommended for colder environments.)
Test light will flash.
Step 1
Step 2