Filter
Top Products
MotionFaçade™ LED User Manual (Rev. 10) Page 9 of 12
Configuration
(Standalone)
Set the product in one of the standalone modes to control without a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
Never connect a product
that is operating in any standalone mode, whether Static,
Automatic, or Sound to a DMX string connected to a DMX controller. This is
because product
s in standalone mode may transmit DMX signals that could
interfere with the DMX signals from the controller.
Sound-Active
Mode
To enable the Sound-Active mode, do the following:
1. Press <MENU> repeatedly until Sound shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select Yes.
4. Press <ENTER>.
5. Turn the music on until the product responds to the beat of the music.
The product will only respond to low frequencies of the music (bass and drums).
Automatic Mode
To enable the Automatic Mode, follow the instructions below:
1. Press <MENU> repeatedly until Automatic shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select Yes.
4. Press <ENTER>.
Master/Slave
Mode
This mode allows a single unit (the “master”) to control the actions of one or more units
(the “slaves”) without the need of a DMX controller. The master unit will
be set to
operate in either Automatic or Sound-Active mode, while the slave units will be set to
operate in Slave Mode. Once set and connected, the slave units will operate in unison
with the master unit.
Configure the units as indicated below.
Slave units:
1. Press <MENU> repeatedly until 8-CH shows on the display.
2. Press <ENTER> to accept.
3. Use <UP> or <DOWN> to select the starting address to: d001.
4. Press <ENTER>.
5. Connect the DMX input of the first slave unit to the DMX output of the master unit.
6. Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
7. Finish setting and connecting all the slave units.
Master unit:
1. Set the master unit to operate in either Automatic or Sound-Active mode.
2. Make the master unit the first unit in the DMX daisy chain.
Wait until all the slave units are configured and connected before connecting the
master unit to the DMX daisy chain.
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because it may interfere with the signals from the master unit.
Do not connect more than 31 slave units to the master unit.
The MotionDrape™ and MotionFaçade™ can also be used together in this mode
with the same configuration.