Filter
Top Products
Rear Panel Control Details
Back
Infrared
Power On/Off
Sound
Back Front
Infrared Switch
Rear of fixture
Bottom of fixture
Back Front
Infrared Switch
Voltage select
Infrared sensor select
1
2
3
4
6
5
7
8
1) On/Off switch: Turn on/off the unit.
2) Power cord: This connection supplies main power to the fixture. Be sure the main power
matches the required power of your fixture.
3) Fuse holder: This housing stores the protective fuse. Always replace with the extra same type
fuse. Replacement with anything other than the specified part may damage your unit.
4) Red LED: Power indicator, Blue LED: Sound indicator.
5) Master/Slave Mode: Select the master/slaver mode.
6) Signal input/output: uses a 3.5mm stereo microphone cable to link the unit together for
master/slave link.
7) AC voltage selector switch
8) Infrared sensor (rear or front) selector switch
Master/Slave Operation
Note: Maximum linking in Master/Slave mode is 8 fixtures.
1) Turn Off all projectors.
2) Connect up to 8 fixtures using a daisy chain method. From the signal output of the first projector
to the signal input of the following projector and then repeat for the following projectors.
3) Set the Master/Slave switch on the first unit in the daisy chain to Master and turn this projector
ON before all other projectors.
Important: Turn Master unit On First otherwise link will not be consistent.
4) On all remaining units set the Master/Slave switch to Slave then turn those projectors on.
LG-3355 User Manual 6 11/14/2007/18:12