Filter
Top Products
Page 9For technical questions, please call 1-800-444-3353.SKU 40457
Set-Up
Assembly Diagrams near the end of this manual.
It is important that you read the entire manual to
become familiar with the unit BEFORE you use the
sure that you have all parts described in the Parts
Assemble attachments based on the intended use
of the tool.
each use. Put back all pieces in the case provided
and store in the case to ensure that no pieces are
lost.
To Insert Accessories:
Insert Collet (2) into the shaft. Slide the 1.
Collet Nut (1) over the Collet. Insert the
desired accessory fully into the Collet.
2.
while turning the Collet Nut (1). You will feel
the Shaft click into place.
With the Shaft locked in place, use the Collet 3.
wrench to tighten the Collet Nut.
Note: Some cutting wheels, polishing tips and
accessories need to be attached or inserted
into another shaft or mandrel to be used.
In these cases, please note the following
instructions.
Thread the accessory onto the screw. Insert 4.
the mandrel into Collet. Following the
preceding steps, tighten the Collet Nut.
To Remove Accessories:
1.
(19) while turning the Collet Nut (1)
counterclockwise. You will feel the Shaft
click into place.
With the Shaft locked in place, use the Collet 2.
wrench to loosen the Collet Nut and remove
the accessory.
Work Piece and Work Area Set Up
1.
lit. The work area must not allow access by
children or pets to prevent distraction and
Route the power cord along a safe route 2.
to reach the work area without creating a
tripping hazard or exposing the power cord
to possible damage. The power cord must
reach the work area with enough extra
length to allow free movement while working.
Secure loose work pieces using a vise or 3.
clamps (not included) to prevent movement
while working.
4.
will present a hazard while working.
You must use personal safety equipment 5.
eye and hearing protection, as well as heavy
work gloves and work apron.
Before beginning work, plan and provide for 6.
surface. CAUTION: Always have access to
Operating Instructions
TO PREVENT SERIOUS
INJURY:
Grip the tool rmly.
To assist you with operation, please refer to
the end of the manual.
Never force the tool or attachment to do the
work of a larger industrial tool. It is designed
rate for which it was intended.
For most uses, it is helpful to grasp the tool 1.