Filter
Top Products
SKU 41903 Page 5For technical questions, please call 1-800-444-3353.
Step 3) While continuing to hold down the Lock Button, use
the 4 mm Hex Wrench to loosen and remove the
Arbor Bolt (part #38). Remove the Spring Washer
(part #37) and the Flange (part #36).
Step 4) Rotate the Retractable Guard (part #32) clockwise
to allow entry of the Saw Blade (part #35).
Step 5) Insert the Saw Blade (#35) up through the
Shoe (part #53) with the teeth facing forward
and up, until the center hole of the Saw Blade fits
over the Main Shaft (part #25) - (See Figure 3).
Warning: Make certain that the arrow on the Retractable Guard (#32) and the Saw Blade
are facing the same direction as in Figure 3.
Step 6) While pressing on the Lock Button, replace the Flange (#36), Washer (#37) and
Arbor Bolt (#38). Tighten into place with the Hex Wrench. When finished, make
certain that the Lock Button has been returned to the up (unlocked) position.
Step 7) Slide the Hex Wrench into its storage slot and tighten it into place with the
Hex Wrench Knob (See Figure 4).
Figure 2-Installing the Saw Blade
Press Stop Button
Hex Wrench
Arbor Bolt (#38)
Directional Arrows
Figure 3
Teeth face up
Depth Adjustment
Knob
Hex Wrench
Hex Wrench
Knob
Bevel Adjustment
Knob (#50)
Shoe
Figure 4
Angle Scale