Filter
Top Products
8. Check for damaged parts. Before using any tool, any part that appears damaged should be carefully
checked to determine that it will operate properly and perform its intended function. Check for alignment
and binding of moving parts; any broken parts or mounting fixtures; and any other condition that may affect
proper operation. Any part that is damaged should be properly repaired or replaced by a qualified
technician. Do not use the tool if any switch does not turn On and Off properly.
9. Replacement parts and accessories. When servicing, use only identical replacement parts. Use of any
other parts will void the warranty. Only use accessories intended for use with this tool. Approved
accessories are available from Harbor Freight Tools.
10. Do not operate tool if under the influence of alcohol or drugs. Read warning labels on prescriptions to
determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate
the tool.
11. Never look directly into the Spotlight.
12. Avoid touching the Lens as it may become hot during operation.
13. Do not dissassemble the Battery or remove any parts from the Battery and surrounding connections.
14. Do not allow the Spotlight to be exposed to fire or high heat as this may result in an explosion.
15. Disconnect power. Unplug charger when not in use.
16. Maintenance. For your safety, maintenance should be performed regularly by a qualified technician.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
Note: Performance of this tool (if powered by line voltage) may vary depending on
variations in local line voltage. Extension cord usage may also affect tool
performance.
Grounding/Voltage Warning
Common household current is 110-120 volts. As long as the outlet used with the tool is rated from 110-120V
there will be no complications using it with household receptacles. Plug the tool into a 110-120V properly
grounded outlet protected by a 15-amp, dual element time delay or circuit breaker.
NEVER try to plug a 110-120V tool into a 220-240V circuit or serious complications and possible injury to the
operator may occur. The plugs have different shapes to prevent this.
Assembly
Your Spotlight comes completely assembled.
Operation
To assist you with operating your Spotlight please refer to Figure 1 on page 5 and to the Parts List and
Assembly Diagram located on pages 5 and 6.
Note: Always recharge the Spotlight within a 24 hour period after each use.
Note: This unit is equipped with an automatic shutoff. If the Battery’s power is running low, the unit will
automatically stop operating to protect the battery. Charge the battery immediately.
#43972 REV 10/02 Page 3REV 06/04