Filter
Top Products
Page 8SKU 46944
NOTE: Some parts are listed and shown for illustration purposes only and are not available
individually as replacement parts.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBU-
TOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE
IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING
OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Note: There are no replacement parts available with this Charger.
ACCESSORIES
1. Handle .................................1
2. Wheels ................................2
3. Axle .....................................1
4. Mounting Foot .....................1
5. Axle Brackets ......................2
6. Cord Cleats .........................6
7. Bag of Hardware .................1
8. Manual ................................1
Symptom: Ammeter needle moves up to full charge, then drops to zero. Makes clicking
noise.
Probable Cause: 1. Battery is completely dead. 2. Defective battery. 3. Charger Engine
Starter is resetting itself after circuit overload. 4. Circuit breaker is cycling. 5. Reverse con-
nections at battery.
Remedy: 1. Continue charging battery. Charger Engine Starter will continue to reset itself
until the battery charge reaches a chargeable level. 2. Check and/or replace battery. 3. Wait
until Charger automatically resets itself. 4. May be the wrong switch position. 5. Shut off
Charger and correct cable lead connections.
Troubleshooting (continued)