Filter
Top Products
Page 15For technical questions, please call 1-800-444-3353.Item 69454
Installing a Threaded Accessory
TO PREVENT INJURY: Wear heavy-duty work gloves when handling wire wheels and brushes.
These accessories are sharp and can cause injury.
Figure E
1. The accessory MUST be:
rated to at least 7800 RPM.
undamaged.
a sanding disc and backing pad,
a sanding flap disc, a wire wheel or
a wire cup brush (accessories not included).
2. Press in and hold the Spindle Lock Button
to prevent the Spindle from turning.
3. Remove the Outer Flange and the
Inner Flange and keep in a safe place.
4. Thread disc accessory firmly onto the Spindle.
Wrench tighten onto the spindle.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route
to reach the work area without creating a
tripping hazard or exposing the power cord to
possible damage. The power cord must
reach the work area with enough extra length
to allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects, such
as utility lines or foreign objects, nearby that
will present a hazard while working.
5. You must use personal safety equipment including,
but not limited to, ANSI-approved eye and hearing
protection, as well as heavy-duty work gloves.
6. Before beginning work, provide for sparks and
debris that will fly off the work surface.
General Operating Instructions
TO PREVENT SERIOUS INJURY: Grip the tool firmly in both hands.
1. Make sure that the Trigger is not
locked on, then plug in the tool.
2. Squeeze the Trigger to start the tool.
To lock the tool on, press the Lock ON
Button then release the Trigger.
3. Allow the tool to come up to full speed
before touching the work material.
4. Apply the wheel to the work material at a 10° – 15°
angle, allowing the tool to operate at full speed.
If the tool bogs down, use lighter pressure.
5. To create a smoother surface,
keep the tool moving over the work surface.
6. Release the Trigger to stop the tool, or press and
release the Trigger if the Lock ON Button is engaged.
7. Allow the tool to come to a complete
stop before setting it down.
8. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of children’s reach.
SAFETYOPERATIONMAINTENANCE SETUP