Filter
Top Products
SKU 90636 For technicial questions, please call 1-800-444-3353. Page 2
SPECIFICATIONS
Item Description
Capability 6 and 12 VDC battery tester with
charging system output
Load Test Capacity 100 amps; 50~1000 cold cranking
amps
Display Meter Analog, 0~16 VDC (maximum)
Test Cycle 10 seconds per test with 1 minute cool
down; 3 tests in 5 minutes
Battery Cable / Clamps 16-3/4 inch; Copper plated clamps
Overall Dimensions 12-3/4 (L) x 6 (W) x 3 (D) inches
Features Carrying handle and four rubber feet
Save This Manual
You will need the manual for the safety warnings and precautions, operating and
maintenance procedures. Keep your invoice with this manual in a safe and dry
place for future reference.
SAFETY PRECAUTIONS
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instruc-
tions listed below may result in electric shock, fire, and/or serious injury.
SAVE THESE INSTRUCTIONS
1. Keep your work area clean and well lit. Cluttered benches and dark areas invite
accidents.
2. Do not operate power tools in explosive atmospheres, such as in the presence
of flammable liquids, gases, or dust. Power tools create sparks which may
ignite the dust or fumes.
3. Keep bystanders, children, and visitors away while operating a power tool.
Distractions can cause you to lose control. Protect others in the work area from
debris such as chips and sparks. Provide barriers or shields as needed.
4. Do not force the tool. Use the correct tool for your application. The correct tool
will do the job better and safer at the rate for which it is designed.
5. Do not use the power tool if the Power Switch does not turn it on or off. Any tool
that cannot be controlled with the Power Switch is dangerous and must be
replaced.
6. Store idle tools out of reach of children and other untrained persons. Tools are
dangerous in the hands of untrained users.