Filter
Top Products
SKU 92496 PAGE 14
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Make sure the Welding Kit is cool to the touch and
disconnected from its oxygen and acetylene cylinders before performing
any inspection, maintenance, or cleaning procedures.
2. BEFORE EACH USE, inspect the general condition of the Welding Kit. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts,
damaged Welding Hoses (D1A, or D1B), and any other condition that may affect its
safe operation. If a problem occurs, have the problem corrected before further use.
Do not use damaged equipment.
3. PERIODICALLY, use the Tip Cleaner (D7) to clean out dirt and debris from the
Nozzle (parts D4). Make sure to use the correct size Tip Cleaner for each individual
Nozzle. (See Assy. Diagram E.)
4. TO CLEAN, use a clean cloth. If necessary, a mild detergent may be used.
Do not immerse any part of the Welding Kit in liquid.
Do not use solvents or other flammable agents to clean the Welding Kit.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND
ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER
THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR
WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE
ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE
ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT
BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT
PARTS THERETO.