Filter
Top Products
SKU 92956 For technical questions please call 1-800-444-3353 PAGE 10
PRODUCT FEATURES
1. Drill Chuck (3) and Chuck Key (33): The Close Quarter Drill is equipped with a
3/8” keyed Drill Chuck (3) that will accept drill bits (not included) with a 1/16” to
3/8” shank. Installing a drill bit into the Drill Chuck requires the use of the
accessory Chuck Key (33). Always make sure the drill bits are firmly secured in
the Drill Chuck prior to using the Drill. (See Figure D.)
2. Trigger (30) and Trigger Lock (34): The Trigger (30) is operated manually
simply by squeezing the Trigger to turn on the Drill and releasing pressure on the
Trigger to turn off the Drill. The Trigger features a Trigger Lock (34) for continuous
running of the Drill. To set the Drill in a continuous run mode, squeeze the
Trigger and depress the Trigger Lock. Then, release pressure on the Trigger.
The Drill will continue to run. To turn off the Drill, squeeze and let up on the
Trigger. (See Figure D.)
3. Forward/Reverse Switch (35): The Forward/Reverse Switch (35) is located
directly above the Trigger (30). For clockwise rotation, move the Forward/
Reverse Switch to the
right
. For a counterclockwise rotation, move the
Forward/Reverse Switch to the
left
. Use the Forward/Reverse Switch only after
the Hammer Drill has come to a complete stop. (See Figure D.)
FORWARD/REVERSE SWITCH (35)
TRIGGER (30) TRIGGER LOCK (34)
DRILL CHUCK (3)
FIGURE D
TO TIGHTEN
TO LOOSEN
CHUCK KEY
(33)
POWER CORD/PLUG
(31)
UNPACKING
When unpacking, check to make sure all accessories listed above are included, and that
the product is intact and undamaged
NOTE:
For additional information regarding the parts mentioned in
the following pages, refer to the Assembly Diagram on page 14.