Filter
Top Products
Page 7SKU 93258
For technical questions, please call 1-800-444-3353.
Installation
The Battery Charger must be installed near the battery in the vehicle. Brackets are provided for this
purpose. You may mount the Battery Charger against the vehicle battery or on the motor compartment
wall. Be sure to allow at least 2-1/2” clearance in front of
the Plug in Access door.
1. Motor Compartment Wall mounting: Use Brackets A and
B as shown in Figure 1. Using the supplied bolts, attach the
brackets and the Battery Charger to the motor compartment
wall. Be careful not to damage any wires, hoses or other
components when attaching.
2. Battery mounting: Use all three brackets as shown in
Figure 2 to mount the Battery Charger against the vehicle
battery. All brackets are bolted together, and Bracket C is
slipped underneath the battery.
3. Ensure that the ignition is off. Connect the Red cable to
the Positive pole of the battery. Connect the Black cable to
the Negative pole of the battery. Make sure that there is a
good connection between the cables and the battery posts.
Make sure that all connections are tight.
WARNING: Do not damage any cables, hoses or components when installing the brackets of battery
Charger.
Be sure the Battery Charger is firmly attached and will not come loose during normal driving or an
unforeseen sudden stop.
Periodically check the Battery Charger to be sure it remains in place. Make any adjustments as
needed.
WARNING: If the battery Charger comes loose, it may become damaged or do damage to engine
components.
Figure 1
Plug in access
Door
Figure 2